Extractor Tool for 1.50mm (.059") CP Crimp Terminals Extractor Tool HD-50424-1 Application Tooling Specification Sheet Order No. 63813-2350 FEATURES This Extractor Tool is for the removal of 64323 Series female terminals from CMC connector. SCOPE Products: 1.50mm (.059") CP Crimp Female Terminal for Power CMC Receptacle. Terminal Series No. Terminal Order No. Housing Series No. 64323-1029 64318, 64319, 64323-1039 64323 64320 and 64321 64323-1219 64323-1319 OPERATION: When removing a damaged crimped wire from the CMC connector follow the steps below: 1. The secondary lock on the CMC connector will need to be opened first. See Figure 1. 2. Using a screwdriver insert the flat edge under the tab of the secondary lock and pull up. Use your fingers to open the lock completely. SECONDARY LOCK WIRE SCREWDRIVER Figure 1 Doc No: ATS-638132350 Revision: A Release Date: 07-01-10 Revision Date: 07-01-10 CMC CONNECTOR UNCONTROLLED COPY Page 1 of 2 Extractor Tool for 1.50mm (.059") CP Crimp Terminals 3. Position the blades of the extraction tool into the two small cavities of the slot in the front face of the housing as shown in Figure 2. Use the identifying markings on both the front and back of the connector to locate the opening used to extract the crimped wire. CRIMPED WIRE SECONDARY LOCK OPEN MARKINGS ON BACK AND FRONT OF HOUSING PUSH EXTRACTOR TOOL INTO FRONT FACE Figure 2 ORIENT BLADES INTO HOUSING CAVITIES 4. Push extractor tool into the desired slot until it clicks or comes to a stop. Do not force the extractor tool any further or there can be damage to the housing. 5. Gently push the wire forward towards the housing and then pull out of the CMC housing. 6. Molex does not offer repair parts for Extractor Tools due to the inexpensive nature of these tools. http://www.molex.com Doc No: ATS-638132350 Revision: A Release Date: 07-01-10 Revision Date: 07-01-10 UNCONTROLLED COPY Page 2 of 2